About 141 results
https://drivepatents.com/patents/1092413 · 22 Oct 2003
The system provides a mounting for the radiator and cooling components in a vehicle, and uses a wedge operating within a defined slot. The wedge may be partially inserted in guide slots, whilst in an open position. It is then fully inserted so that it is r...
https://drivepatents.com/patents/1092538 · 15 Oct 2003
Aportion between a front end of an air guide plates (18), which forms an air duct portion (11), and the front exterior member (9,10) of the vehicle is sealed by a seal portion. Therefore, hot air leaking from inside of an engine room, is positively prevent...
https://drivepatents.com/patents/1093393 · 10 Sep 2003
The radiator attachment has a holder (5) fastened to the body of the vehicle and with two legs, the first (8) of which is fastened to the body of the vehicle and the other (9) connected to the holder by a film hinge (10). The opening direction of the secon...
https://drivepatents.com/patents/1093934 · 20 Aug 2003
The front cooler (2) is movable upwards and optionally forwards so that the middle cooler (3) can be swung out sideways essentially at a right angle, without the rear cooler (4) getting in the way.
https://drivepatents.com/patents/1096517 · 2 May 2003
A swivel body (2) is mounted horizontally swivelably on a traveling device (1) and provided thereon with a hydraulically-operated working system (7). Assuming that a side end of the swivel body where the hydraulically-operated working system is provided se...
https://drivepatents.com/patents/1100686 · 30 Oct 2002
A heat exchanger assembly (102) including a condenser assembly (106), a radiator assembly (104), a fan shroud (108), and a clip (204) for retaining the condenser assembly (106) and a method of assembly. The clip (204) includes a base (302), a first engagin...
https://drivepatents.com/patents/1101207 · 9 Oct 2002
A means is provided to increase the efficiency of a vehicle engine cooling and supplementary, heat pump type cabin heating system. A flexible panel (26) located in front of and below the front end heat exchanger (24) can be moved between open and blocking ...
https://drivepatents.com/patents/1101161 · 9 Oct 2002
The mounting for a car radiator has a lower section (20) which fits into an aperture in a cross-member and an upper section (19) which contains a recess (15). A pin on the radiator fits into this and can slide into a groove (17) connected with it if the ra...
https://drivepatents.com/patents/1101141 · 9 Oct 2002
The mounting for a car radiator (10) comprises a block (12) which is attached to a cross-member (11) which contains a recess (15). A pin (13) on the radiator fits into this and can slide into a groove (17) connected with it and then into a second recess (1...
https://drivepatents.com/patents/1102351 · 21 Aug 2002
To improve repairability of an automotive front body structure provided with a shroud 1 comprising a radiator holding portion 11 for holding a radiator 2, by preventing the radiator 2 held in the radiator holding portion 11 form damage as possible even if ...