About 201 results
Showing the first 200 results.
https://drivepatents.com/patents/1083965 · 15 Sep 2004
An oil drip dish fits underneath a crankcase (2,4) to form an oil extraction area (OEA) (16), from which lubricating oil (LO) is fed to consumers via a main oil pump with an oil suction pipe. LO from the consumers returns via oil pipes (42,44) to oil colle...
https://drivepatents.com/patents/1084150 · 8 Sep 2004
Exhaust gas from the engine flows through a magnetic valve from a catalyser to a vacuum reservoir and via a non-return valve to a suction pump. A motor control system is connected to the valve. Data for engine revs (n), vehicle speed (v), load (L) and enga...
https://drivepatents.com/patents/1084330 · 1 Sep 2004
The removable car roof is made up of two sections (7) divided down the center line of the car. They are stored one above the other with the concave sides facing inwards in a storage compartment. Their corners are held by recesses (16 -18) in the compartmen...
https://drivepatents.com/patents/1084345 · 1 Sep 2004
The cooling system for a rear-mounted vehicle drive system (3, 4) comprises air inlets (8, 9) in the vehicle underbody (13) which feed air (A) over the gearbox (3). This forms a cool air zone (KL) and a warm air zone (WL) over the engine with a temporary t...
https://drivepatents.com/patents/1084360 · 1 Sep 2004
The lock (8) for a removable car roof (5) comprises a push button (12) which releases a rotating control plate (13). This is connected by a shaft to the locking mechanism and unlocks it.
https://drivepatents.com/patents/1084368 · 1 Sep 2004
Friction clutch (1) for a drive unit of a motor vehicle comprises a clutch release device (10) arranged in a housing (13) and having a clutch release bearing (12) and a hydraulic actuating device (11) with a cylinder housing (14) containing an actuating pi...
https://drivepatents.com/patents/1084357 · 1 Sep 2004
The roof (8) for a convertible is made up of two sections side-by-side and is supported by the windscreen and roll bar. Latches (13) which hold the roof in place cooperate with rubber buffers (25, 26) to prevent its inner surface approaching too close.
https://drivepatents.com/patents/1084412 · 1 Sep 2004
The lining is drawn around a raised edge of the cut-out and glued to a molded lining element. Clamps (7-10) are mounted on the outer side (1a) of the lining element (1) in the corners of a rounded cut-out (3). The clamps have an angled profile, and the lin...
https://drivepatents.com/patents/1084350 · 1 Sep 2004
The drive unit for a sports car has a casing (47) fitted with bearings (19) for the drive shaft (21) and driven shaft (22) which are mounted transversely. The clutch is mounted in a chamber (26) below these, while above them is a second chamber (24) for dr...
https://drivepatents.com/patents/1084356 · 1 Sep 2004
A locking device for a removable motor vehicle (1) roof (3) extending between a windshield and a roll-over bar (4) comprises a bolt and receiving socket attached to the bar in a holding plate (13). The plate comprises a cover element (22) which is movable ...